Error Messages and System Messages

Successful calls to the JADE Object Manager return a value of zero (0). If a value other than 0 is returned, it is your responsibility to determine the cause of the error and take the appropriate action.

Throughout this document, references to the JADE log file refer to the file defined by the LogFile parameter in the [JadeLog] section of the JADE initialization file. By default, this file is named jommsg.log.

 

 

 

 

 

 

 

 

 

 

 

 

 

Jade Software Corporation Limited cannot accept any financial or other responsibilities that may be the result of your use of this information or software material, including direct, indirect, special or consequential damages, or loss of profits. There are no warranties extended or granted by this document or software material.

You should be very careful to ensure that the use of this software material and/or information complies with the laws, rules, and regulations of the jurisdictions with respect to which it is used. No part of this document may be reproduced or transmitted in any form or by any means, electronic or mechanical, for any purpose, without the express written permission of Jade Software Corporation Limited.

The information contained herein is subject to change without notice. Revisions may be issued to advise of such changes and/or additions.

Copyright © 2018 Jade Software Corporation Limited.

All rights reserved.

JADE is a trademark of Jade Software Corporation Limited. All trade names referenced are the service mark, trademark, or registered trademark of the respective manufacturer.

For details about other licensing agreements for third-party products, you must read the JADE ReadMe.txt file.